beautypg.com

Locating the new water heater, A caution, Typical installation – Maytag HE21250S User Manual

Page 8: Awarning, Locating the neiv water heater, Instructions for installation (cont'd)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Instructions for Installation (cont'd)

Locating The New Water

Heater

You should carefully choose an indoor location for the new
water heater, because the placement is a very important con'

sidération for the safety of the occupants in the building and

for the most economical use of the appliance. This water
heater is not intended for outdoor installation.

Whether replacing an old water heater or putting the water
heater in a new location, the following critical points must be

observed,

1, The location selected should be indoors as close to and as

centralized with the water piping system as possible. This

water heater, as well as all water heaters, will eventually
leak. Do not install without adequate drainage provisions
where water flow will cause damage.

A CAUTION

WATER HEATERS EVENTUALLY LEAK: Installation of
the water heater must be accomplished in such a

manner that if the tank or any connections should
leak, the flow of water will not cause damage to the

structure. For this reason, it is not advisable to install
the water heater in an attic or upper floor. When
such locations cannot be avoided, a suitable drain

pan should be installed under the water heater.
Drain pans are available at your local hardware

store. Such a drain pan must have a minimum diam>

eter of at least IV

4

inches greater than the water

heater diameter and must be piped to an adequate
drain. Under no circumstances is the manufacturer or
Maytag to be held liable for any water damage in

connection with this water heater.

A CAUTION

INSTALLATION IN RESIDENTIAL GARAGES: The water
heater must be located and/or protected so it is not

subject to physical damage by a moving vehicle.

2, The location selection must provide adequate clearances for

servicing and proper operation of the water heater.

VACUUM RELIEF REQUIRED BY SOME CODES

Typical Installation

CHECK ALL CONNECTIONS FOR LEAKS.
CONSULT THE LOCAL UTILITY COMPANY TO EXAM­
INE INSTALLATION FOR PROPRIETY AND SAFETY.

*AWARNING

HOTTER WATER CAN SCALD: Water heaters are
intended to produce hot water. Water heated to a

temperature

which

will

satisfy

clothes

washing,

dish washing, and other sanitizing needs can scald
and permanently injure you upon contact. Some
people are more likely to be permanently injured by
not water than others. These include the elderly,
children, the infirm, or physically/mentaily handi­
capped. If anyone using hot water in your home fits

into one of these groups or if there is a local code or
state law requiring a certain temperature water at

the hot water tap, then you must take special pre­

cautions. In addition to usin^ the lowest possible

temperature setting that satisfies your hot water

needs, a means such as a mixing valve, should be
used at the hot water taps used by these people or
at the water heater. Mixing valves are available at
plumbing suppiy or hardware stores. Follow manu­

facturers instructions for installation of the valves.

Before changing the factory setting on the thermo­
stat, read the 'Temperature Regulation" section in

this manual.

This manual is related to the following products: