Converting the lower element (cont'd), Instructions for installation (cont'd) – Maytag HE21250S User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Instructions for Installation (cont'd)
Converting the Lower Element
(cont'd)
1. Before beginning the conversion turn “OFF” electric
power supply to the water heater.
4. Lower Element: Lift out the tab as shown to unclip the
terminal cover from the thermostat. The terminal cover
can now be removed from the thermostat.
Lift out tab to undip
terminal
cover
from
thermostat.
A WARNING
HAZARD OF ELECTRICAL SHOCK! Before removing
any access panels or servicing the water heater,
make sure the electrical supply to the water heater
is turned "OFF". FAILURE TO DO THIS COULD
RESULT IN DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
2. The convertible element is located behind the lower access
panel of the water heater. Remove the two screws securing
the access panel, and remove panel.
5. Remove the screws from terminal 2 of the element, and
move the looped end of the wire aside.
3. Open the flap of insulation to expose the opening.
6. The buss bar is labeled 5500 W. Place the buss bar over ter
minals 2 and 3 with the 5500 W visible. Install the extra
screw provided into terminal 3.
13