A warning, A caution, Installation instructions – Maytag HE21250S User Manual
Page 7: Removing the old water heater
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing the Old Water Heater
^^^Turn “OFF” electrical supply to the water heater.
Installation Instructions
©
Turn “OFF” the water supply to the
water heater at the water shutoff valve
or water meter.
©
/TLLK
Attach a hose to the water heater drain
valve and put the other end in a floor
drain or outdoors. Open the water
heater drain valve. Open a nearhy hot
water faucet which will relieve pressure
in the water heater and speed draining.
A WARNING
The water passing out of the drain
valve may be extremely hot. To
avoid being scalded, make sure all
connections are tight and that the
water flow is directed away from
any person.
a. If you have copper piping to the water heater, the two
copper water pipes can be cut with a hacksaw approxi
mately four inches away from where they connect to
the water heater. This will avoid cutting off the pipes
too short. Additional cuts can be made later if neces
sary. Disconnect the temperature-pressure relief valve
drain line. When the water heater is drained, discon
nect the hose from the drain valve. Close the drain
valve. The water heater is now completely disconnect
ed and ready to be removed.
b. If you have galvanized pipe to the water
heater, loosen the two galvanized pipes
with a pipe wrench at the union in each
line. Also disconnect the piping remain
ing to the water heater. These pieces
should be saved since they may be needed
when reconnecting the new water heater.
Disconnect
the
temperature-pressure
relief valve drain line. When the water
heater is drained, disconnect the hose
from the drain valve. Close the drain
valve. The water heater is now completely
disconnected and ready to be removed.
^4^ Check again to make sure the electrical supply is turned
“OFF” to the water heater. Then disconnect the electri
cal supply connection from the water heater junction
box.
A CAUTION
Mineral buildup or sediment may have accumulated
in the old water heater. This causes the water
heater to be much heavier than normal and this
residue, if spilled out, could cause staining.