Maytag HE21250S - Manual (Page 23)

Service and Maintenance (cont'd)
Element Cleaning/
Replacement (cont'd)
19. The adjustment dial has a “D” shaped opening that match­
es a “D” shaped shaft on the thermostat. Align the opening
in the dial to the shaft and gently push the dial onto the
shaft.
o
TUlNl CfF
ravicrhi
10 moK
POL
KTje^er cmBi
(a)
20. Replace access panel.
21. Turn “ON” electric power to water heater.
Drain Valve Washer
Replacement
NOTE: For replacement, use a
’yjj"x 'V m " x
V s " thick washer
available at your nearest hardware store. For ordering a
replacement washer, refer to the “Repair Parts” section.
1. Before beginning turn “OFF” the electrical power supply
to the water heater.
AWARNING
HAZARD OF ELECTRICAL SHOCK! Before removing
any access panels or servicing the water heater,
make sure the electrical supply to the water heater
is turned "OFF". Failure to do this could result in
DEATH, SERIOUS BODILY INJURY, OR PROPERTY
DAMAGE.
2. Follow “Draining” instructions in the “Service and
Maintenance” section.
3. Turning counter clockwise, remove the hex cap below the
screw handle.
4. Remove the washer and put the new one in place.
5. Screw the handle and cap assembly back into the drain
valve and retighten using a wrench. DO NOT OVER
TIGHTEN.
6. Follow “Filling the Water Heater” instructions in the
“Instructions for Installation” section.
7. Check for leaks,
8. Turn “ON” electric power to the water heater.
Service
Before calling for repair service, read the “Start Up
Conditions” and “Operational Conditions” found in the
“Troubleshooting” section of this manual.
If a condition persists or you are uncertain about the opera­
tion of the water heater, let a qualified person check it out.
Call Maytag Customer Service at 1-800-788-8899.
23