SINGER 221K Featherweight User Manual
Page 47
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
45
CLEAN
X
CLEAN
BETWEEN
TENSION
DISCS
When in regular use—
The machine should be cleaned
periodically to remove the lint and
fluff which may have accumulated
around the working parts.
To remove face plate, turn hand wheel
until take-up lever reaches its highest
point, then remove face plate thumb
screw, raise face plate and carefully pass it
toward you over end of take-up lever.
Clean the area inside. Remove bobbin
case and throat plate and clean stitch-
forming mechanism.
After each cleaning, oil the machine
as instructed on
pages 46 and 47.
If the machine is to be stored for an
indefinite period, brush away all traces
of lint and fluff, then swab all exposed
parts with a lint free brush saturated
with SINGER* oil to protect against
rust damage.
The area in head of machine that should be cleaned
and covered with a protective coat of oil is shown at left.
Also clean stitch-forming mechanism and cover
exposed parts with a coat of oil.
TO CLEAN THE MACHINE