SINGER 221K Featherweight User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO WIND BOBBIN—Continued
Place spool of thread on spool pin.
Thread machine as shown above.
Hold end of thread and start ma
chine. (End of thread will break
oflf after a few coils have been
wound on bobbin.)
If thread doesn’t wind e^venly
on bobbin—
•
Loosen screw which holds bobbin
winder tension bracket to bed of
machine.
•
Move bracket to left if bobbin
winds high on right.
•
Move bracket to right if bobbin
winds high on left.
• Tighten tension bracket screw.
When bobbin is full—
• Stop machine.
• L i f t b o b b i n
winder
away
from belt.
•
Remove bob
bin.
•
Tighten stop
motion screw.
This manual is related to the following products: