SINGER W1365 - Manual (Page 27)

26
4.
' 5.
When
1 .
2
.
3.
4.
5.
Clean the shuttle race, the shuttle, and shuttle race cover by removing all threads, Imt, etc.
Apply a drop of oil with finger tip to outer edge of shuttle,
the cleaning has been completed, proceed as follows to replace the shuttle assem ^.
Turn the balance wheel until the needle reaches its highest position.
Place shuttle body, ( D i , against shuttle driver and adjust into position. ^
Replace shuttle race cover, i C , , fitting pin at lower edge into notch, and lock mti.
position with shuttle race cover clamps, i B , , making certain the clamps have been
snapped securely into position.
Put bobbin into the bobbin case. ^ u v i
Put the bobbin case into the shuttle race, fitting tongue into notch P oi race
r
cove:
ACCESSORIES
1 Plastic Oiler
2 Package of needles
3 Bobbins (3)
4 Felt Washers
(for spool pins)
5 Needle Plate for
Straight Sewing
6 Small Screw Driver
7 Large Screw Driver
8 Quilter Guide
9 Cloth Guide
10 Thumb Screw
11 Button Sewing Foot
12 Buttonhole Foot
13 Presser Foot for
Straight Sewing
14 Small Hemmer Foot