SINGER W1365 - Manual (Page 15)

14
REMOVING THE WORK
Be sure to stop the machine when the thread take-up
lever and needle bar are located at the highest position.
Now' raise the presser foot and draw the fabric back and
to the left, Fig. 21-A and B, and pass the threads over the
thread cutter.
Pull down slightly, holding thread in both hands, so as
not to bend the needle.
Leave the ends of thread under the presser foot.
CREATIVE EMBROIDERY
Be sure zigzag presser foot and zigzag needle plate are
in place. .
, The satin stitch, Fig. 22,
which is really just a very short
zigzag stitch, and the basis for
22
most embroidery, is obtained by setting the stitch length as
near 0 as possible without stopping the feeding action.
The width may be set anywhere from just past 0 to the
widest, 4-
Fig. 21-B