SINGER W712 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
SETTING THE NEEDLE
See Fig. 6 . Raise the needle bar A to its highest
point, turning wheel toward you by hand. ■
Then loosen the needle clamp screw B and the
needle can be inserted into clamp C, Place needle
(flat side to rig lit) in the needle clamp and pusii it
far as Tt wm go into the needle clarrip
hole, tightening the needle ciarnp screw securely
with a screw driver.
Flat surfa
oE needle
shank
1 /
r
After changing the needle make one com
plete
revolution
of
the
balance
wheel
by
hand to be sure the needle is in the correct
position.
Fig. 7
Fig. 6
THREADING THE BOBBIN CASE
Step 1 illlustrated in Fig. 8 ). Hold bobbin case between thumb and forefinger of left han
so that the slot in the edge of the bobbin case is on top. Take the bobbin between thumb ai
forefinger of right hand so that the thread on top leads from left to right.
Step 2. Insert bobbin into bobbin case, pull the thread into the slot of the bobbin case ^
shown in Fig. 9, and draw it under tension spring and into the fork-shaped opening of the - sprii
as shown in Fig. 1 0 .