Preparing to sew, Removing the work – SINGER W712 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

P R E P A R I N G T O S E W

have take-up lever at highest point before starting to sew. Do not try to help the feeding

by pulling the material as this may deflect the needle and cause it to break.

NEVER run machine without material under presser foot.

Pidce material and threads in position under the presser loot and lower the presser foot. You

are now ready to begin sewing. By having the needle at its highest point, it is not necessary

to touch the hand wheel to start the machine. You merely press the control. The speed of the

machine is regulated by increasing or decreasing the amount of pressure exerted on the control.

Fig. 21A

REMOVING THE WORK

Be sure to stop the machine

v/hen

the

thread

take-up

lever

and needle bar are at the highest
position.

Now

raise

the

presser

foot

and draw the fabric back and to
the left fFig. 21, A and B) and pass

the threads over the thread cutter.

Pull

down

slightly,

holding

thread in both hands, so as not
to bend the needle.

Leave the ends of thread un

der the presser foot.

Fig. 21B