Oiling the mach ine – SINGER W203 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Oiling the Mach ine
When the machines are received from the factory, they should be
thoroughly cleaned and oiled,
be oiled at least twice a day.
When In continuous use, they should
Fig.
2.
Front View of Machine
145W103
Showing Oiling Points
Oil should be applied at each of the places designated by arrows
In Figs. 2, 3, 4, 5 and 25.
Fig. 3. Rear View of Machine
Showing Oiling Points and Adjustments
Loosen the thumb screw In the upper end of the face plate, turn
the face plate upward and oil the wick and bearings which are thus
uncovered, then turn dcwn the face plate and tighten the thumb screw.
Fig. 4. End View of Machine Showing Oiling Points
Also Adjustments on the Machine
Apply a few drops of oil four times dally to the felt pad In the
side wall of each bobbin case as Illustrated In Fig. 10.
J K
Fig. 5. Base of Machine Showing Oiling Points and Adjustments