SINGER 9134 - Manual (Page 17)

INSERTING A WOUND BOBBIN
To insert a bobbin, follow the instructions below.
• Raise presser foot.
• Turn hand wheel toward you until needle
is in its highest position.
• Open slide plate and remove bobbin.
1. Pull 4" (10cm) of thread from replace­
ment bobbin and insert bobbin into
case, as shown.
2. Holding bobbin in place, guide thread
into notch (1), and then into notch (2).
3. Draw several inches of thread across
bobbin.
4. While holding thread on outside, close
slide plate. •
• Follow directions for “Raising Bobbin
Thread” on page 16-
15