SINGER 7110 - Manual (Page 7)

mmomuG amd replacimg needle
PLATE
® Raise presser foot
@ Raise needle to highest position.
® Open slide plate. Place thumb under right
side of needle plate, lift It up and withdraw
it to right.
® Replace needle plate under clamping pin A,
push it gently to the left and press down
until it snaps into place.
ATTACHING SNAP-IN FEED COVER
® Raise presser foot.
® Raise needle to highest position by turning
hand wheel toward you. Open slide plate.
® Slide snap-in feed cover away from you
over needle plate until points B and C are
positioned directly over holes in needle plate
as illustrated. Snap in point Then push
point C in toward point B until it snaps into
place. Close slide plate. To remove, open
slide plate then simply lift up front edge of
feed cover.
ATTACHING BLINDSTITCH HEM GUIDE
® Raise presser foot, loosen presser foot
screw with a coin and slip blindstitch hem
guide between screw and shank of the
general purpose foot.
® Be sure underside of the guide clears the
slide plate and front of foot.
® Tighten screw with a coin.