SINGER W8418 - Manual (Page 6)

Placi^ & o UU h . Qa4.e i4€ SUuUle
1. Raise the presser bar by lifting the presser bar lifter.
2. Raise the needle bar to its highest position by turning the
balance wheel toward you.
3. Pull out slide plate (Fig. 9).
4. Hold the bobbin case latch (Fig. 10) between the thumb
and forefinger of the left hand, with at least three inches
of thread running from the top of the bobbin case to the
right. Insert and center the bobbin case on the stud of
bobbin case finger is
Press the bobbin case
until latch catches on
the shuttle body. Be sure the
opposite the shuttle race notch,
into the shuttle as far as possible
the center post of the shuttle.
5. THEN release the bobbin case latch, Press bobbin case
again after latch has been released. To make sure the
bobbin case is locked securely in place. Close the cover
plate.