Casio PA-2400W - Manual (Page 55)

55
Table 7.6 List of termination codes
Error Code
Category
code
Detail
code
Meaning Possible Cause Remedy
00h 00h Normally terminated Normal. -
DCh to
F5h
00h Normally terminated Formatting of drive a:between 'A'
and 'Z' is specified from the
partner station. (For drive letter
definitions, refer to Chapter
7.7 “Method of Describing
Pathname”.) Refer to Chapter 7.5
“Restrictions”.
F6h 00h Normally terminated Power-off is specified from the
partner station. Turn off the power.
F7h 00h Normally terminated. Resetting the power is specified
from the partner station.
Refer to Chapter 7.5
“Restrictions”.
F8h 00h Terminated due to interruption. Communication is terminated
because the break key is pressed
on the PA-2400W (local station)
or partner station. Resume communication as
required.
01h 00h Protocol error Data anomaly (data error
occurred on the communication
line). Check the communication
line connection.
02h 80h File not found Non-existent file is specified. Check the specified file or
directory.
02h 81h Current directory delete error An attempt has been made to
delete the current directory. Check the objective
directory of deletion.
02h 82h File write error Write to the file is not possible. Check if the file is ready to
be written.
02h 83h File read error Read from the file is not possible. Check if the file is ready to
be read from.
02h 84h Read only access error An attempt has been made to
overwrite or delete the read-only
file. Specify another file name or
cancel the read-only
attribute.
0Fh 01h Argument parameter error Incorrect argument description Check the argument
parameter.
0Fh 02h Argument too long Argument portion of the
command line is too long Reduce the length of the
argument including FLCE to
255 characters or less.
A0h 10h Communication port open error One of the other programs is
using COM1 or IrDA,or FLCE is
already initiated. Terminate the program that
is using COM1 or IrDA.
Either the cable was unplugged
during communication or the
IrDA connection is broken
(where the PA-2400W is
dismounted from I/O Box). Check the cable connection
and mounting condition of
the PA-2400W on I/O Box. A0h 20h Line break error or IrDA
duplicate open error
IrDA port is already open. Terminate the other
program that is using IrDA.
A0h 30h Session-wait timeout error Session was not established
within 1 minute of startup. Check the cable connection
or check if the IrDA is ready
for communication.