AT&T AT&T 7650 - Manual (Page 3)

I N S T A L L A T I O N
PHONE light goes on while
handset is on a call.
Base Antenna
(extended)
CHARGING light goes on while
handset battery is charging.
Directory Card
LO ВАТТ BASE goes on when
base battery power is low.
Use CLOCK with CHANGE to
set or change time/day.
Message Alert
Ringer Switch­
Ring Select
Use ANNC with CHANGE to
record outgoing announcement.
Use CHANGE wUh
CLOCK and ANNC.
Page/Find
WALL M0UNTIN8 INSTALLATION
1 Follow Steps 1-5 in TABLE
INSTALLATION.
2 Choose and mark the mounting
position.
The mounting screws should screw
into a wooden smd within the wall.
Use the Wall Mounting Template
and a pencil to mark the screw
positions on the wall.
3 Install the mounting sleeves and
screws.
Start the screw holes in the marks
you made on the wall. Now slip
the mounting sleeves onto the
screws, with the larger end of the
sleeve toward the screw head.
'i c .iCrc '.'S ill i''c I’c’ y~".
started, and tighten until the smaller
end of the sleeve is flat against the wall.
4 Reverse the switchhook.
In order to "hang up" the handset
when the base is wall mounted,
you'll need to remove the
switchhook, reverse it, and replace
it Lii die bci^e.
Connect the telephone line cord.
Plug one end of the telephone line
cord into the jack on the top side of
the base. Plug the other end of the
line cord into a modular jack. Make
sure the plug snaps firmly in place.
Mount the base on the wall.
Hold the base so the mounting
sleeves on the wall fit into the holes
on the bottom of the base. Slide
the base down onto the mounting
sleeves until it locks into place.
Follow Steps 7-9 in TABLE
INSTALLATION.
Setting the Clock
The clock feature will record the day and
time of each message received.
To set the clock
1 Press CHANGE . then clock '. Y
ou hear
a day of the week.
2 Press REPEAT' or FORWARD'. Until yOU
hear the correct day.
3 Press CLOCK to hear the hour.
4 Press REPEAT or FORWARD Until yOU
hear the correct hour. Make sure
the hour is correct for AM or PM.
5 Press CLOCK' to hear the minute.
6 Press REPEAT or FORWARD Until yOU
hear the correct minute.
7 Press CLOCK . You will hear the day
and time setting.
To review the clock
• Press
CLOCK . You will hear the day
and time settins.