beautypg.com

Start id marking options, Auto id level – Tascam DA-P1 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Start ID Marking Options

AUTO ID Mode

CZD

I

—■»I AUTO i5~l~-

1 \''

-Start IDs-

r

WA /

y

1

/

There must be more

than 9 seconds.

AUTO ID Level

MARGIN RESET ID SELECT

CD

Manual Start ID Writing

Start IDs are electronic index marks in the subcode area of the tape that make it easy to

find the start of each selection on the tape. You can make Start ID marks during the

initial audio recording, or add them to the recording later. Consider the following

possibilities before actually initiating audio recording :

In this mode, Start ID and program number will automatically be recorded at each
occurrence of audio level exceeding -48 dB or user selected decibels (discussed

below) after a lapse of about 3 second lower levels or silence. (The first Start ID and
program number after the deck is put into record mode are recorded when sounds
exceeding a selected level are fed into the deck, regardless of the length of preceding

lower signals or silence.) To put the deck into AUTO ID mode, press the ID SELECT
switch to have "AUTO ID" light up in the display window.

Note that a quiet passage ("pianissimo") might cause the beginning of the next passage
to be indexed and numbered as if it were a new program. Don't worry. You can correct

it (with "Erase Start") later.

Restriction : No Start ID is automatically recorded unless there is more than 9
seconds since the previous Start ID.

The sensitivity of the AUTO ID circuit defaults to -48 dB but can be set to -42, -54,
-60 or -66 dB. To change the sensitivity level:

(1) When no ID editing mode is selected, hold down MARGIN RESET and press ID

SELECT. The current sensitivity level will blink in the left of the display window.

(2) Press MARGIN RESET until the desired level shows.

(3) Press ID SELECT to make the setting effective.

O’ The setting is switched back to -48 dB when turning off the deck.

You can manually index the beginning of each program. Program time is automatically

recorded together with Start IDs.

o There must be 9 seconds or more between two Start ID marks for the correct search

function.

To enter Manual Start ID Writing mode :

Press ID SELECT until "WRT START" shows in the right of the LCD display.

A Start ID is laid down on tape when you hit RECORD after putting the deck into

record. (You can also hit RECORD during play too.)

A Start ID recording lasts about 9 seconds and is noted by "WRT START" flashing in
the right of the display.

IT#- While a Start ID is being written, all transport buttons except for STOP are

disabled.

Before starting audio recording, consider the possibility of recording Skip and End ID
marks. See below for an explanation.

9