Tascam DA-P1 - Manual (Page 20)

Specifications
Format : Rotary head digital audio tape deck
Record Time : 120 minutes (with 120-min tape)
Fast Winding Time : Approx. 60 seconds
Tape Speed : 8.15 mm/sec. (12.225 mm/sec. during
play)
Quantization : 16-bit linear
Error Correction Method : Octuple error correction
Drum Speed : 2,000 rpm
Sampling Rates:
48 kHz recording (digital/analog), play
44.1 kHz recording (digital/analog), play
32 kHz recording (digital only), play
Channel : 2 channels
Frequency Response : 20 Hz to 20 kHz, ± 0.5 dB
(44.1/48 kHz) (LINE)
S/N : Better than 90 dB (LINE)
Dynamic Range : Better than 90 dB (LINE)
Total Harmonic Distortion : Better than 0.007%, 1 kHz
(LINE)
Channel Separation : Better than 85 dB (1 kHz)
Wow and Flutter : Unmeasurable (less than ±0.001%)
Analog I/O
MIC/LINE IN (XLR-3-31 x 2)
MIC
Nominal level : -60 dBm (0.8 mV)
PAD : 20 dB
Input impedance : 2.5 kohms, balanced
LINE
Nominal level : +4 dBm (1.2 V)
Input impedance : 10 kohms, balanced
LINE IN (RCA X 2)
Nominal level : -10 dBv (0.3 V)
Input impedance : 35 kohms, unbalanced
LINE OUT (RCA x2) :
Nominal level : -10 dBv (0.3 V)(10-kohm load)
Output impedance : 500 ohms, unbalanced
PHONES (1/4" jack x 1)
Max. output level : 15 mW -i-15 mW (32 ohms)
Digital I/O
IN (RCA X 1) : lEC 958 TYPE II (S/PDIF)
OUT (RCA X 1) : lEC 958 TYPE II (S/PDIF)
Power Supply : 2-way (AC adaptor PS-Dl and Ni-Cd
battery BP-Dl (7.2 V, 1.4 Ah))
U.S.A./Canada : 120 VAC, 60 Hz
Europe : 230 VAC, 50 Hz
U.K./Australia : 240 VAC, 50 Hz
Power Consumption :
13W (with PS-Dl, during OPERATE)
15W (with PS-Dl, during CHARGE)
Battery Charging Time : Within approx. 2.5 hours
Battery Life : Approx. 120 minutes (continuous
recording, PHANTOM OFF), approx. 100 minutes
(continuous recording, PHANTOM ON, (2 mA x
2)), Approx. 180 minutes (stop)
Dimensions (WxHxD) : 258 x 54 x 188 mm (10-3/16" x
2-1/8" X 7-3/8")
Weight : 1.2 kg (2-10/16 lbs) (excluding battery
(240 g))
Supplied Accessories : AC adaptor/battery charger
(PS-Dl), Ni-Cd battery (BP-Dl), and Carrying belt
o In these specifications, 0 dBv is referenced to I Volt,
and 0 dBm is referenced to 0.775 Vrms. Actual
voltage levels are also given in parenthesis (0.316 V
for -10 dBv rounded off to 0.3 V).
o Changes in specifications and features may be made
without notice or obligation.
DA-PI External Dimensions
20