Tascam DA-P1 - Manual (Page 2)

Important Safety Precautions
AI
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
lA
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
A
A
The lightning flash with arrowhead symbol, within equilateral triangle, is intended to alert
the user to the presence of uninsulated "dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a risk of electric shock to person.
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
This appliance has a serial number located
on the rear panel. Please record the model
number and serial number and retain them
for your records.
Model number________________________
Serial number-------------------------------------
WARNING: TO PRIVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT (for U.K. Customers)
DO NOT cut off the mains plug from this
equipment. If the plug fitted is not suitable for the
power points in your home or the cable is too short to
reach a power point, then obtain an appropriate safety
approved extension lead or consult your dealer.
If nonetheless the mains plue is cut off, remove
the fuse and dispose of the
p 1 u 2 immediately,
to avoid a possible shock hazard by inadvertent
connection to the mains supply.
If this product is not provided with a mains plug, or one
has to be fitted, then follow the instructions given
below:
IMPORTANT. DO NOT make any connection to the
larger terminal which is marked with the letter E or by
the safety earth symbol or coloured GREEN or
GREEN-and-YELLOW.
The wires in the mains lead on this product are coloured
in accordance with the following code:
BLUE: NEUTRAL
BROWN: LIVE
As these colours may not correspond with the coloured
markings identifying the terminals in your plug proceed
as follows:
The wire which is coloured BROWN must be connected
to the terminal which is marked with the letter L or
coloured RED.
When replacing the fuse only a correctly rated approved
type should be used and be sure to re-fit the fuse cover.
IF IN DOUBT — CONSULT A COMPETENT
ELECTRICIAN.
The wire which is coloured BLUE must be connected to
the terminal which is marked with the letter N or
coloured BLACK.