To interrupt a clean cycle, To set delayed self-clean cycle, When a clean cycle is finished – Sears KENMORE 46520 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO SET SELF-CLEAN CYCLE:
1. Close oven door. Push CLEAN, The time display will
show (—). See Fig. 1. You may need to press
slightly on the door.
0
0
FIg.l
2. Press
0
or
0
to set the desired length of clean
time. Clean time is normally 3 hours. You can
change It between 2 and 4 hours, depending on how
dirty the oven Is. See Fig. 2. The door locks
automatically after the controls are set. The display
will show “LOCK” when door locks.
TO INTERRUPT A CLEAN CYCLE;
1. Push CLEAR/OFF.
Follow
instructions
under
“WHEN
A
CLEAN
CYCLE IS FINISHED.”
TO SET DELAYED SELF-CLEAN
CYCLE:
Follow steps 1-3 under “TO SET SELF-CLEAN
CYCLE,” THEN:
4. Press STOP TIME.
5. Set the time of day when you want the clean cycle to
end. See Fig. 4.
The control will calculate the start clean time.
Fig. 2
You can push STOP TIME to find out when the cycle
will end. Push CLEAN to return to countdown.
WHEN A CLEAN CYCLE IS
FINISHED:
1. Wait until the LOCK display goes out. The oven
temperature must drop to a safe level before the door
can be opened. See Fig. 3.
Note: When selecting a stop time for a delayed clean
cycle, you must allow time for the 2-4 hour clean
time.
Your oven light should be OFF during a self-clean cycle
to prolong the life of the bulb.
WAIT UNTIL LOCK GOES OUT
Fig.3
If you cannot open the door Immediately after the word
LOCK goes off, wait about one minute and try again.
14
NESCL07-1