Sears 917.2565 - Manual (Page 8)

ASSEMBLY
CONNECT BATTERY (See Figs. 2 and 3)
A
CAUTION: Do not short battery termi­
nals. Before connecting battery, re­
move
metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from acciden­
tai grounding.
® Remove cardboard packing from seat pan and lift seat
pan to raised position.
® Open battery box door,
® Remove terminal protective caps and discard.
0
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
•> First connect RED battery cable to positive (+) terminal
with hex bolt, flat washer, lock washer and hex nut as
shown. Tighten securely.
» Connect BLACK grounding cable to negative (-) termi­
nal with remaining hex bolt, flat washer, lock'washer
and hex nut. Tighten securely.
• Close battery box door.
Cpen battery box door for:
- Inspection for secure connections (to tighten hard­
ware).
® Inspection for corrosion.
® Testing battery.
• Jumping (if required).
® Periodic charging .
BATTERY -
BOX DOOR
FIG.3
INSTALL SEAT (See Rg. 4)
Adjust seat before tightening adjustment bolt.
•> Remove cardboard packing on seat pan.
® Place seat on seat pan and assemble shoulder bolt.
® Assemble adjustment bolt, lockwasherandflatwasher
loosely. Do not tighten.
» Tighten shoulder bolt securely.
® Lower seat into operating position and sit on seat.
® Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way
down.
® Get off seat without moving its adjusted position.
® Raise seat and tighten adjustment bolt securely.
8