Sears 917.2565 - Manual (Page 15)

CUSTOMER RESPONSIBILITIES
MAINTENANCE SCHEDULE
FILL IN DATES
AS YOU COMPLETE
vO'
1 - Change more often when operating under a heavy toad or in high ambient temperatures.
2 Service more often when operating in dirty or dusty conditions.
3 - If equipped with oil fifter, change oil every 50 hours.
4 - Replace blades more often when mowing in sandy soit.
T
R
A
C
T
0
R
Check Brake Operatio?’ ✓ ✓
Check Tire Pressure
✓ t /
Check for Loose Fasteners
✓ ✓ 7 1/
Sharpen/Replace Mower Blades
✓ <1
Lubrication Chart
✓ ✓
Check Battery Levei/Recharge
✓ e
Clean Battery and Terminals
✓ ✓
Check Transaxie Cooling
✓
Adjust Blade Beltfs) Tension
✓ s
Adjust Motion Drive Belt(s) Tension
✓ ,5
mmm=>
E
N
G
!
N
E
Check Engine Oil Level
✓ ✓
1
Change Engine Oil |
✓ ✓
1
Clean Air Filter
j
l/g
Clean Air Screen ✓ 2 I
inspect Muffter/Spark Arrester
✓
1
Replace Oil Filter (If equipped)
1^,2 1
Clean Engine Cooling Fins
t/z I
Replace Spark Plug |
✓ ✓ ! 1
Replace Air Filter Paper Cartridge
✓ z I I
Replace Fuel Filter
✓
I
5 - If equipped with adjuslabie system.
6 - Not required if equipped with maintenance-free battery,
7 - Tighten front axie pivot bolt to 35 ft.-ibs, maximum.
Do not overtighten.
GENERAL RECOMMENDATIONS
The warranty on this tractor does not cover items that have
been subjected to operator abuse or negligence. To
receive full value from the warranty, operator must maintain
tractor as instructed in this manual.
Some adjustments will need to be made periodically to
property maintain your tractor.
Ail adjustments in the Service and Adjustments section of
this manual should be checked at least once each season.
• Once a year you should replace the spark plug, clean
or replace air filter, and check blades and belts for
wear. A new spark plug and clean air filter assure
proper air-fuel mixture and help your engine run better
and last longer.
BEFORE EACH USE
• Check engine oil level.
• Check brake operation.
• Check tire pressure.
“ Check for loose fasteners.
LUBRICATION CHART
(D SPINDLE 2ERK
@ FRONT WHEEL­
BEARING ZERK
(D ATTACHMENT-
CLUTCH
PiVOT(S)
SPINDLE ZERK®
FRONT WHEEL®
'■ BEARING ZERK
ENGINE®
1 5
®SAE 30 OR 10W30 MOTOR OIL
©GENERAL PURPOSE GREASE
@ REFER TO CUSTOMER
RESPONSIBILITIES “ENGINE” SECTION
IMPORTANT; DO NOT OIL OR GREASE THE PIVOT POINTS
WHICH HAVE SPECIAL NYLON BEARINGS. VISCOUS LUBRI­
CANTS WILL ATTRACT DUST AND DIRT THAT WILL SHORTEN
THE LIFE OF THE SELF-LUBRICATING BEARINGS. IF YOU
FEEL THEY MUST BE LUBRICATED, USE ONLY A DRY POW­
DERED GRAPHITE TYPE LUBRICANT SPARINGLY.