Sears 917.2565 - Manual (Page 13)

OPERATION
TO OPERATE MOWER (See Fig. 7)
Your tractor is equipped with an operator presence sens­
ing switch. Any attempt by the operator to leave the seat
with the engine running and the attachment clutch engaged
will shut off the engine.
® Select desired height of cut. '
® Start mower blades by engaging attachment clutch
control.
TO STOP MOWER BLADES ■
clutch control. disengage attachment
CAUTION: Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the dis­
charge guard in place.
TO OPERATE ON HILLS
A
CAUTION: Do not drive , up or down
hilis with slopes greater than 15° and
do not drive across any slope.
® Choose the slowest speed before starting up or dowr
hilis.
® Avoid stopping or changing speed on hills.
® If slowing is necessary, move throttle control lever tc
slower position.
» If stopping is absolutely necessary, push clutch/brake
pedal quickly to brake position and engage parking
brake.
• Move gearshift lever to 1 st gear. Be sure you have
allowed room for tractor to roll slightly as you restart
movement.
*■ To restart movement, slowly release parking brake and
clutch/brake pedal.
® Make all turns slowly.
TO TRANSPORT
® Raise attachment lift to highest position with attach­
ment lift control.
® When pushing or towing your tractor, be sure gearshift
lever is in neutral (N) position.
® Do not push or tow tractor at more than five (5) MPH.
NOTE: To protect hood from damage when transporting
your tractor on a truck or a trai ler, be sure hood is closed and
secured to tractor. Use an appropriate means of tying hood
to tractor (rope, cord, etc,).
BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL (See Fig. 12)
® The engine in your tractor has been shipped, from the
factory, already filled with summer weight oil.
» Check engine oil with tractor on level ground.
• Remove oil fill cap/dipstick and wipe clean, reinsert the
dipstick and screw cap tight, wait for a few seconds,
remove and read oil level. If necessary, add oil until
“FULL” mark on dipstick is reached. Do not overfill.
® For cold weather operation you should change oil for
easier starling (See “OIL VISCOSITY CHART" in the
Customer Responsibilities section of this manual).
® To change engine oil, see the Customer Responsibili­
ties section in this manual.
13