Sears 83 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. While another person holds the Upright (13) near
the Frame (1) as shown, connect the Extension Wire
(23) to the Reed Switch Wire (39). Next, connect the
Resistance Cable (19) to the Lower Cable (29) in the
following way:
• See drawing A. Pull up on the metal bracket on
the Lower Cable (29), and insert the tip of the
Resistance Cable (19) into the wire clip inside of
the metal bracket as shown.
• See drawing B. Firmly pull the Resistance
Cable (19) upward and slide it into the top of the
metal bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (23, 39) and the Cables (19, 29)
downward into the Frame (1).
Next, insert the Upright (13) into the Frame (1).
Be
careful to avoid pinching the wires and cables.
Attach the Upright with three M8 x 15mm Button
Screws (34) and three M8 Split Washers (42).
The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
Press the tab on the battery cover and remove it.
Insert four batteries into the Console as shown.
Make sure that the batteries are oriented as
shown by the diagram on the battery cover.
Then, reattach the battery cover.