Sears KENMORE 911.41369 - Manual (Page 9)

тш тшш,
гш®
continued
f
Уош new control has а seríes of tones that will
sound at different times. These tones may
sound while you set the control for an oven
function, or at the end of the oven function. It
will also alert you there maybe a problem with
the functions. Below are the types of tones
and a brief description of each.
TOMES WMILE ШЕТТШй ТШ
CQMtmL
When you press a touch pad you will hear a
beep. This beep will let you know you have
placed enough pressure on the pad to
activate it. (The arrow pads do not beep.)
EMD OF TIUED €¥€LE ТШЕ
At the end of a timed cooking function, you will
hear 3 short beeps followed by 1 beep every
6 seconds. This 6 second beep will continue
to sound until the CLEAB/OFf pad is pressed
or you may select the special feature to cancel
this 6 second beep from sounding at the end
of future cycles.
TO CANCEL THE 6 SECOND BEEP
1. Press and hold the ВАШ and BROIL
pads, at the same time for 3 seconds,
until the display shows ^‘SF”.
2. Press the KITCHEN TIMER 0M/OFF
pad. The display will show “CON BEEP”
(continous beep).
3. Press the MITCNEN TIMER ON/OFf
pad again. The display will show “BEEP”
(beep canceled).
4. Press the START pad.
If you would like to return the 6 second beep
repeat steps above until the display shows
your choice and press start.
ATTENTION TOME
This tone will sound if you make an error or an
oversight is made while setting an oven
function.
Examples would be:
a. Setting a clean cycle and the oven door is
not properly closed.
Setting a function and not pressing the
START pad.
G. Pressing an additional function pad
without first setting a temperature or time.
Any of these can be quickly identified by
watching the display.
PREHEAT TOME
When you set an oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches the
temperature you have set, a tone will sound to
let you know the oven is ready for baking.
If you set an oven function and the control
beeps while the display is flashing “F” and a
number “F-4” or letter “FI” there may be a
problem with the control or oven. Simply
press the CLEAR/OfF pad and wait about
an hour. Try setting the function again. If the
code repeats, write down the flashing code
and call for service. Tell the technician
what the code was flashing.