Sears 200.71988 - Manual (Page 8)

6.2 12V DC Electrical Device Example Run-Time Chart
Appliance Type Estimated Power Estimated
Time*
Fluorescent Lights, Cellular Phones 4 Watts 50 Hours
Radios, Depth Finders, Fans 9 Watts 25 Hours
Camcorders, DVD Players, Spotlights 15 Watts 13 Hours
Electrical Tools, Bilge Pumps 24 Watts 7.3 Hours
Electric Coolers 48 Watts 4.5 Hours
Air Compressors, Car Vacuums 80 Watts 2 Hour
*NOTE: Estimated run-times. Actual time may vary. Times are based on
the internal battery being new, fully charged and operating at room tem­
perature.
7. USING THE USB PORT
The USB port on the 1150 provides up to 500mA at 5VDC.
7.1 Turn the JUMP START ON/OFF switch to the ON position.
7.2 Plug the device into the USB port on the front panel of the 1150.
7.3 Turn USB device ON.
7.4 Reverse these steps when finished using the USB port.
8
.
USING THE BUILT-IN LIGHT
8.1 Position the 1150 on a flat, stable surface near the intended work area.
8.2 Push the power switch to the LIGHT position. The light will turn on and
illuminate your work area.
NOTE: With a fully charged internal battery, the built-in light should pro­
vide 18 to 30 hours of continuous, useful light.
8.3 Push power switch to the OFF position when work is completed.
8.4 Charge the 1150 as soon as possible after using the built-in light.
NOTE: With a fully charged internal battery, the built-in light should
provide 18 to 26 hours of continuous useful light, depending on ambient
conditions.