Sears 200.71988 - Manual (Page 13)

IMPORTANT:
• CHARGE IMMEDIATELY AFTER PURCHASE
• KEEP FULLY CHARGED.
Charge the 1150 internal battery immediately upon purchase, every 30
days and after every use.
All batteries are affected by temperature. The ideal storage temperature is
between 40 and 70 degrees Fahrenheit. The internal battery will gradually
self-discharge (lose power) over time and more quickly in warm environ­
ments. Leaving the battery in a discharged state may result in permanent
battery damage. To ensure satisfactory performance and avoid permanent
damage, charge the internal battery every month.
When the JUMP START ON/OFF switch is ON, the clamps are live and
will produce arcing or sparking if they come in contact with each other. To
prevent accidental arcing, always keep the clamps on the storage holders
and the JUMP START ON/OFF switch in the OFF position when not using
it to jump start a vehicle.
18.1 Replacing the built-in light
To replace the built-in light bulb:
1. Turn the light off.
2. Insert a standard (flat blade) screwdriver into one of the two slots along
the bottom of the plastic lens and GENTLY pop the lens out. Repeat for
the other side.
3. Gently grasp the bulb and twist counter-clockwise one quarter-turn to
unscrew the bulb.
4. Insert a replacement bulb of the same type and rating, and twist clock­
wise one quarter-turn to screw in the new bulb.
5. Replace the lens cover.
6. Test the light by switching the light on and off.
18.2 Customer Technicai Assistance
Customer technical assistance is available Monday-Friday, 7 am to 4:30
pm Central Time by phoning 1-800-SEARS-64.
18. STORAGE AND MAINTENANCE
11