Tools required for assembly, To removetractor from carton, Unpack carton – Sears 917.25156 User Manual
Page 7: Before rolling tractor off skid, Attach steering wheel (see fig. 1), Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Your newtractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
■
■
..................................... id hardware you assemble must be tightened securely. Use
To ensure safe and proper operation of your tractor al! parts an
the correct tools as necessary to insure proper tightness
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
Tire pressure gauge
Utility knife
{2) 7/16" wrenches
(1) 1/2" wrench
(1) 9/16" wrench
{1) 3/4“ socket with drive ratchet
When right or left hand is mentioned in this manual, it
means when you are in the operating position (seated
behind the steering wheel).
TO REMOVETRACTOR FROM CARTON
UNPACK CARTON
<■ Remove all accessible loose parts and parts cartons
from carton (See page 6).
•
Cut, from top to bottom, along lines on all four corners
of carton, and lay panels flat.
» Check for any additional loose parts or cartons and
remove.
BEFORE ROLLING TRACTOR OFF SKID
ATTACH STEERING WHEEL (See Fig. 1)
» Remove hex bolt, lock washer and large flat washer
from steering shaft.
» Position front wheels of the tractor so they are pointing
straight forward.
” Slide steering sleeve over steering shaft,
•
Position steering wheel so cross bars are horizontal
(left to light) and slide onto steering wheel adapter.
•
Secure steering wheel to steering shaft with hex bolt,
lock washer and large flat washer previously removed.
Tighten securely.
•
Snap steering wheel insert into center of steering
wheel.
•
Remove protective plastic from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRES V^HERE TRACTOR
IS TO ROLL OFF SKID.
TO ROLL TRACTOR OFF SKID (See Operation
section for location and function of controls)
» Press lift lever plunger and raise attachment lift lever to
its highest position.
•
Release parking brake by depressing clutch/brake
pedal.
•
Place freewheel control in freewheeling position to
disengage transmission (See 'TO TRANSPORT’ in
the Operation section of this manual).
" Roil tractor forward off skid.
" Remove mower and packing materials.
» Remove ties from V-beits.