Sears 831.299581 - Manual (Page 14)

El
During heart rate pro­
grams, the program
display will show a
graphic that represents
your heart rate. Each
time a heartbeat is de­
tected, an additional
peak will appear.
Enter your age.
HEwramE^cowTBOL
oo#ooool
00*0000
0 0 * 0 0 0 0
* * 0 * 0 * *
0 0 0 0 * 0 0 .
HEART RATE V
O C C
n a C
FATCALS. CALS.
When a heart rate pro­
gram is selected, the let­
ters AGE and the current
age setting will begin to
flash in the Calories/
Fat Calories/Heart Rate
display. You must enter your age to use a heart
rate program. If you have already entered your
age, go to step 5. If you have not entered your
age, press the Incline (Age Set) buttons until your
age is shown. Your age will then be saved in mem­
ory.
I Press the Start button or the Speed A button to
I
start the program.
A moment after the button is pressed, the tread­
mill will automatically adjust to the first speed and
incline settings for the program. Hold the handrails
and begin walking.
Each heart rate program is divided into one-minute
segments. (The Time^ndine/Segment Time dis­
play will show both the time remaining in the pro­
gram and the time remaining in the current seg­
ment of the program.) One target heart rate set­
ting is programmed for each segment. (The same
target heart rate setting may be programmed for
consecutive segments.)
When only three seconds remain in the first one-
minute segment of the program, a series of tones
will sound and the Time/Incline/Segment Time
display and the Speed/Min-Mile display will flash.
The speed and/or incline of the treadmill will then
change, if needed, to bring your heart rale closer to
the target heart rate setting for the next segment.
The program will continue in this way until no time
remains in the program. The walking belt will then
slow to a stop.
If the speed or incline setting for the current seg­
ment is too high or too low, you can adjust the set­
ting with the Speed or incline buttons. However, if
you cfecrease the speed, the incline will automati­
cally
increase, if you increase the speed, the in­
cline will decrease. If you increase the incline, the
speed will decrease, if you cfecrease the incline,
the speed will increase. The treadmiii wiil always
attempt to keep your heart rate near the target
heart rate setting for the current segment. Note:
When the incline reaches the lowest setting, the
speed cannot be increased any further. When the
incline reaches the highest setting, the speed can­
not be decreased any further.
If your pulse is not detected during the program,
the letters PLS wili flash in the Calories/Fat
Calories/Heart Rate display and the speed and in­
cline of the treadmill may automatically decrease
until your pulse is detected. If this occurs, refer to
the instructions included with the chest pulse sen­
sor.
To stop the program at any time, press the Stop
button. Heart rate programs should not be stopped
temporarily and then restarted. To use a heart rate
program again, reselect the program and start it at
the beginning.
i9 Follow your progress with the displays.
Refer to step 5 on page 10.
B When the program is completed, remove the
key from the console.
Refer to step 6 on page 13.
14