Sears KENMORE 385. 12708 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION 2, PREPARE THE MACHINE FOR SEWING
• Wind the Bobbin (Continued)
bobbin winding tension disc as shown. bobbin as shown.
spindle with end of thread coming
from the top of the bobbin. Push
bobbin winding spindle to the right
until it clicks. Holding onto end of
thread, start machine. When bobbin is
slightly filled, snip off end of thread.
Push bobbin winding spindle to the
left and clip thread. Remove bobbin.
Turn clutch knob away from you
while holding hand wheel for normal
sewing operation.
• Insert the Bobbin into the Bobbin Case
Place bobbin in bobbin case
making sure thread feeds clock
wise and is coming from
bobbin as shown.
Pull thread through slot of case
as shown.
Pull thread under tension
spring and through the opening
as shown above. P u M 3 t o 4
inches of thread from bobbin.
Holding latch open, position
case into shuttle and release
latch.
Case should lock into place
when latch is released.
10