Zigzag stitches (continued) – Sears 385.1884180 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTiON. 3. LEARN THE STiTCHES
Zigzag Stitches (Continued)
» fVlonogramnnjng
Set the l^aehine
Stitch width
corttro! 6 to 6
4
Top thread tensiort
controt 2 to 6
ts>
Stitch length
control 0.5 to 1
.1^
Stretch Stitch
F: Satin stitch
foot
Embroidery
Here's How
1.
Set the same as satin stitch.
2.
Back the fabric with paper or
interfacing.
3.
Draw the letters on the fabric
with tailor's chalk.
4.
Satin stitch, adjusting the stitch
width as necessary to form each
pattern.
5.
if using paper, carefully remove it
when you have finished sewing.
Set ttis Machine
Stitch width
control 1 to 6
2
.i
1,
Top thread tension
control 2 to 6
CO
CD
Stitch length control
Any number (not
necessary to adjust)
No presar
foot
Darning plate
Here's How
1.
Put the darning plate on the needle
plate (see page 32).
2.
Remove foot holder (see page 10).
3.
Adjust the stitch width as desired
(see page 23).
4.
Draw the design on to the fabnc
with tailor's chalk.
5.
Stretch the fabric between embroi*
dery hoops -and place under the
needle.
6.
Lower the presser foot lever to
engage the top thread tension.
7.
Holding the top thread in your left
hand, rotate the hand wheel toward
you one complete turn.
Pull the top thread to draw the
bobbin thread through to the surface
of the fabric.
8.
Using a medium speed, stitch along
the
marked
outline,
guiding
the
fabric carefully by hand.
38