Sears 315.17506 - Manual (Page 20)

MAINTENANCE
A
WARNING:
When servicing use only identical Craftsman replacement
parts. Use of any other parts may create a hazard or
cause product damage.
GENERAL
Only the parts shown on parts list, pages 23,25 and 27 are
intended to be repaired or replaced by the customer. All other
parts represent an important part of the double insulation
system and should be serviced only by a qualified Sears
service technician.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
dean cloths to remove dirt, carbon dust, etc.
A
WARNIK.G:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
When electric tools are used on fiberglass boats, sports cars,
wallboard, speckling compounds, or plaster, it has been
found that they are subject to accelerated wear and possible
premature faHure, as the fiberglass chips and grindings are
highly abrasive to bearings, brushes, commutators, etc.
Consequently it is not recommended that this too! be used for
extendeq) work on any fiberglass material, wallboard,
spackling compounds, or plaster. During any use on these
materials, it is extremely important that the tool is cleaned
frequently by blowing with an air jet.
A
WARNING;
Always wear safety goggles, or safety glasses with side
shields during powertool operation or when blowing dust.
If operation is dusty, also wear a dust mask.
EXTENSION CORDS
The use of any extension cord will cause some loss of power.
T
0 keep the loss to a minimum and to prevent tool overheating,
use an extension cord that is heavy enough to carry the
current the tool will draw.
A wire gage size (A.W.G.) of at least 14 is recommended for
an extension cord 100 feet or less in length. When working
outdoors, use an extension cord that is suitable for outdoor
use. The cord's jacket will be marked WA.
A
CAUTION:
Keep extension cords away from any routing area and
position the cord so that it will not get caught on lumber,
tools, etc., during routing operation.
A
WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use tool with a damaged cord
since touching the damaged area could cause electrical
shock resulting in serious injury.
Page 20