Proper care of cutters, Proper care of collet, Lubrication – Sears 315.17506 User Manual
Page 19: Helpful hints, Maintenance, Warning, Light bulb replacement
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE
LIGHT BULB REPLACEMENT
See
Figure 20.
m
UNPLUG YOUR ROUTER.
A
WARNING:
Failure to unplug your router could result in accidental
starting causing serious injury.
Remove cutter from router.
Adjust router to maximum height.
Remove screws (A) and subbase (B).
See Figure 20.
Remove screw (C) and work tight lens (D).
With bulb (E) pointing toward you, push bulb in and
turn to the left to remove from bulb socket.
NOTE:
Light bulb removal and installation is similar to
removing and installing a standard automotive bulb.
Install new bulb by reversing the above procedure.
►
Reassemble ali parts and tighten screws securely.
PROPER CARE OF CUTTERS
Get faster and more accurate cutting results by keeping
cutters clean and sharp. Remove all accumulated pitch and
gum from cutters after each use.
A cutter sharpening kit {Item No. 9-66501) is available from
Sears Retail Stores.
When sharpening cutters, sharpen only the inside of the
cutting edge. Never grind the outside diameter. Be sure
when sharpening the end of a cutter to grind the clearance
angle the same as originally ground.
PROPER CARE OF COLLET
From time to time, it also becomes necessary to clean your
collet and collet nut. To do so, simply remove collet nut from
collet and clean the dust and chips that have collected. Then
return collet nut to its original position.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.
HELPFUL HINTS
/ Always clamp workpiece securely before routing.
/ A safe operator is one who thinks ahead.
/ Always wear eye protection when routing.
/ Make set-up adjustments carefully. Then double check. Measure twice and cut once.
/ Keep cutters clean and properly sharpened.
Don’t let familiarity make you careless.
/ Study all safety rules and do the job safely.
/
NEVER
place your hands in jeopardy.
/ Make certain clamps can’t loosen while in use.
/ Test difficult set-ups on scrap — Don’t waste lumber.
/ Plan each operation before you begin.
/ Clean your router frequently. This will provide smoother operation of depth adjusting ring and locking knob areas.
Shake router or blow with an air jet to remove sawdust build-up.
/ THINK SAFETY BY THINKING AHEAD.
Page 19