How to fold and move the treadmill – Sears PRO FORM 831.29776 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE

Before folding the treadmill, adjust the incline to the lowest

position. If the incline Is not at the lowest position, the
treadmill will be permanently damaged. Next, unplug the

power cord. Caution: You must be able to safely lift 45

pounds (20 kg) in order to raise, lower, or move the

treadmill.

1. Hold the treadmill with your hands in the locations shown

at the right. Caution: To avoid pinching your hands, do

not hold the treadmill in the locations Indicated by the
arrows. To decrease the possibility of injury, bend

your legs and keep your back straight. As you raise

the treadmill, make sure to lift with your legs rather

than your back. Raise the treadmill about halfway to the

vertical position.

2. Move your right hand to the position shown and hold the

treadmill firmly. Raise the treadmill until the storage latch

closes over the frame guide. Make sure that the storage

latch closes fully over the frame guide.

To protect the floor or carpet from damage, place a

mat under the treadmill. Keep the treadmill out of di

rect sunlight. Do not leave the treadmill in the storage

position In temperatures above 85* Fahrenheit.

HOWTO REMOVE THE COVER PANEL

When the treadmill is in the storage position, the woodgrain

finish cover panel will be displayed. If desired, the cover

panel can be removed to expose the black finish of the frame

cover. To remove the cover panel, insert your fingers be

tween the lower end of the cover panel and the frame cover
at the position indicated by the arrow. Pull the cover panel off
the panel fasteners. Work your way up until the cover panel

is removed.

Using a Phillips head screwdriver, remove one of the panel

screws and panel fasteners from the frame cover. Screw the
panel screw back into the frame cover. Press the removed

panel fastener onto one of the fasteners on the cover panel.

Repeat this process,removing one panel fastener at a time,
until all six panel fasteners are removed. Store the cover
panel away from moisture and dust.