Sears 758.14451 - Manual (Page 7)

Grasp the water bottle handle, and lower
into the cabinet. The "E-Z-Fiil Side-Cap"
must be facing the center of the cabinet.
When positioned properly, the plunger will
open and water wili flow into the cabinet.
The water level will automatically remain at
approximately 1 ” until the bottle is empty,
The unit is now ready for operation.
Operating Humidifier Controls
The operating controls of your Kenmore
Quiet Comfort whole house humidifier are
located on the top right of the humidifier.
The controls are found under the smoked
control cover.
Lift the rantrol cover by placing your finger
in the round cutout and lifting. The cover
will stay open. Now you can dearly see the
control area. Familiarize yourself with the
controls and reference the diagram of the
control area for the correct naming used in
this manual.
To Operate the Controls
Humidity Control:
Adjust the amount of humidity depending
on your needs. The humidifier will turn on
and off as required to maintain level of
humidity selected. MEDIUM setting is rec­
ommended, but there are times when low
or high amount of humidity nrtay be pre­
ferred. For constant operation of humidi­
fier, MAX allows for the maximum amount
of humidity to be evaporated into the air
continuously.
IMPORTANT: Water damage may result if
condensation starts to form on windows
or walls. Humidity Control setting should
be lowered until condensation no longer
forms.
Speed Control
The higher the air flow speed, the more
water is evaporated and released into the
air. Low speed is the quietest and is pro­
vided for conditions that may not require
as high an evaporation rate.
Fill Light
When the unit has a small amount of
water left in it, the fit! light will come on
and the unit wili automatically shut off.
Fan Control
Your Kenmore Quiet Comfort Whole
House humidifier has a three speed fan
control switch. (Low, Medium and High)
The maximum humidity output is obtained
with the fan control on high.