Sears 758.14451 - Manual (Page 6)

Water Fill
WARNING: To reduce the risk of
shock, always unplug humidifier
before, cleaning, or servicing. :
WARNING: To reduce the risk of fire
or shock hazard, do not pour or spill
water into control or motor area.
Close the control cover If controls
get wet, let them dry completely and
have unit checked by authorized ;
service personnel before pitigging
in. ■ ^
This humidifier is designed for use with
the water bottle located under the bottle
cover to the left of the fan assembly. The
unit should be positioned where it will be
operating.
To fill the whole house humidifier, close
the control cover and remove the bottle
cover. To remove the water bottle, lift the
bottle straight up and out of the cabinet.
The water bottle is designed with an
“E-Z-Fill Side-Cap”. Remove the “E-Z-
Fill Side-Cap" on the side of the water bot­
tle by twisting counterclockwise.
Place the opening of the water bottle under
a water feucet (the bottle should fit under a
four-inch clearance faucet). Fill with recom­
mended mijcture of cold water and Sears
Bacteiriostat #42-14900 only. Solid debris
could make the valve teak.
Install the “E-Z-Fill Side-Cap” by twisting
clockwise, Hand tighten only.
Check for possible leaks by performing
ftie following:
1. Grasp bottle handle and hold the bottle
upright over a sink.
2. Press up on valve cap plunger for about
one second to let out a little water.
3i Release the plunger.
4. Listen for air bubbles. Look for leaks
around “E-Z-Fili Side-Cap”.
5, if you hear air bubbles or see leaks,
retighten “E-Z-Fill Side-Cap" and repeat
steps 14, , , ■
Wipe off excess water from the bottle.
Position ttie water bottle back into the unit.