beautypg.com

Oil (see fig. 10), Gas (see fig. 10), To start engine – Sears 917.372852 User Manual

Page 10: Operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

OPERATION

TO EMPTY GRASS CATCHER (See Rg. 9)

» Simply lift up rear door and remove the grass catcher

by the handle.

NOTE; Do not drag the bag when emptying; it will cause
unnecessary wear.

before

starting

engine

OIL (See Fig. 10)

Your lawn mower is shipped without oil in the engine

Be sure mower is level and area around oil fill Is clean.

« Remove engine oil cap w/dipsiick and fill to the full line

on the dipstick..

“ Use 20 ozs. of oil. Fortypeand grade ofoilto use. see

“ENGINE” in Cuslamer Responsibilities section of this
manual,,

“ Pour oil slowly. Do not over fill

Check oil level before each use Add oil if needed. Fill

fo full line on dipstick.,

To read proper level, tighten engine oil cap each time

Reinstall engine oil cap and tighten..

« After the first two (2) hours of mowing, change the oil,

and every 25 hours thereafter. You may need to
change the oii more often under dusty, dirty conditions.

GAS (See Fig. 10)

Fill gasoline tank with fresh, dean, unleaded gasoline.
DO NOT USE PREMIUM GASOLINE. BE CAREFUL

NOT TO OVER FILL TANK.

WARNING:

Experience indicates that alcohol blended

fuels (called gasohol or using ethanol or methanol) can
attract moisture which leads to separation and formation of
acids during storage. Acidic gas can damage the fuel
system of an engine white in storage. To avoid engine
problems, the fuel system should be emptied before stor­
age of 30 days or longer Drain the fuel tank, start the
engine and let it run until fuel fines and carburetor are
empty. Use fresh fuel next season, See Storage instruc­
tions for additional information Never use engine or
carburetor cleaner products in fuel tank or permanent
damage may occur.

TO START ENGINE

To start a cold engine, push primerfive (5) times before
trying to start. Lise a firm push. This step is not usually
necessary when starting an engine which has already
run for a few minutes

<* Push engine speed control lever to fast {•^) position

Hold operator presence control bar down to the handle
and puli starter handle quickly Do not allow starter
rope to snap back,

To stop engine, release operator presence control bar.

NOTE;

In cooler weather if may be necessary to repeat

priming steps, in warrrser weather over priming may cause
flooding and engine will not start. !f you do flood engine,
wait a few minutes before attempting to start and do not
repeat priming steps.

10