Sears CROSS WALK 831.297311 - Manual (Page 7)

The CROSS WALK features the innovative ACCUSMART
console, designed to help you get the most from your
workouts. The ACCUSMART console offers electronic
speed control, finger-touch incline control and a motiva­
tional fitness monitor with four independent displays.
Please read the instructions below before operating Hie
console. Note: If there is a sheet of clear plastic on the
face of the console, remove it before operating the con­
sole.
INSTALiING BATTERIES
The motivational fitness monitor requires two "AA" bat­
teries (not included); alkaline batteries are recommend­
ed. Slide the battery cover open. Remove the battery clip
from the console. Find Hie markings inside Hie battery
clip showing which direction the batteries should be
turned. Press the batteries into the battery clip. Replace
the battery clip in the console and close the battery
cover.
Battery G>\«r
NJ— Battery Clip
n
TURNING ON THE POWER
S^> onto the foot rails of the CROSS WALK and hold
the upper body arms. (See OPERATING THE UPPER
BODY ARMS on page 8.) Locate the clip attached by a
cord to rt>e safely key. Slide the clip onto your waist­
band.
CAUTION: Do not stand on the walking belt while turn­
ing on the power. Always wear the clip while operat­
ing the CROSS WALK.
Insert the safety key into Hie power switch. The power
indicator will light. The four displays of the motivational
fitness monitor will not appear until the ON/CLEAR but­
ton is pressed or the walking belt begins to move. (See
CONTROLUNG THE SPEED OF THE WALKING BELT
below.) Note: If batteries were just installed, the four dis­
plays will appear already.
CONTROLUNG THE SPEED OF THE WALKING BELT
For your safety, frie walking belt will be motionless each
time the power is turned on. To start the walking belt,
first turn the speed control knob to the "RESET" position.
Nect, turn the knob slowly clockwise until the walking
belt begins to move at slow speed.
CAUTION: After the knob is fumed, there will be a
brief pause before the walking belt begins to move.
Adjust the speed slowly until you are familiar with the
operation of the CROSS WALK.
Step carefully onto the walking belt and begin exercis­
ing. Change the speed of the walking belt as desired by
turning the speed control knob. To stop the walking belt,
turn the knob to the "RESET" position.