Power-mate™ care, Warning, Light bulb changing – Sears L0711256 User Manual
Page 14: Belt changing and brush cleaning, To remove belt
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
POWER-MATE™ CARE
Always follow all safety precautions when
cleaning and servicing the POWER-MATE™.
A
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
servicing or cleaning the unit.
Failure to do so could result in elec
trical shock or personal injury from
cleaner suddenly starting.
LIGHT BULB CHANGING
1. Remove light
cover by pressing
in and lifting both
sides as shown.
Push
In
And Turn
2. Push in and turn
bulb counterclock
wise to remove.
3. Replace the bulb.
Bulb must not be
higher than 15 Watts.
Close light cover until
it snaps in piace.
NOTE:
See PARTS AND FEATURES for
Bulb #.
BELT CHANGING AND BRUSH CLEANING
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build
up frequently in the POWER-MATE™ brush
and brush support areas. If build-up
becomes excessive, disconnect POWER
MATE™ from wand and follow the steps
below. Instructions can also be found under
the light cover.
TO REMOVE BELT:
1. Remove light
cover and light
bulb as shown
under LIGHT
BULB
CHANGING.
2. Unscrew the
POWER
MATE™ cover
screws.
3. Turn
POWER
MATE™ over.
To remove
cover, insert
screwdriver at
cover tabs on
both sides and
twist to
release tabs.
Quick
Relsass
4. Turn POWER
MATE™ right
side up. Press
handle release
pedal and lower
the swivel. Tilt
cover fonvard
from back until
front snaps free.
14