Sears L0711256 - Manual (Page 12)

HOW YOUR VACUUM WORKS
The vacuum cleaner creates suction that
picks up dirt. Rapidly moving air carries the
dirt to the dust bag through the air­
flow passages. The dust bag
lets the air pass through, while
it traps the dirt.
For best cleaning results,
keep the airflow passage
open. Check the starred
areas occasionally for
clogs. Unplug from
outlet before
checking.
HOSE SWIVEL
The hose swivel
allows the hose to
turn without moving
the canister. This is
helpful for cleaning in
small areas. Check
hose for twisting before pulling canister.
%
1
#
CANISTER CARE
BAG CHANGING
For best cleaning results, the dust bag
should be changed often. The performance
indicator will come on when the bag needs
to be changed or the airflow is blocked.
NOTE: See PARTS AND FEATURES for
Bag #.
1. Unplug cord from
wall outlet.
2. Pull hood release
out and up, then lift
canister hood.
3. Disengage
cardboard tab from red
bag mount by pressing
away and lifting up.
4. Pull bag out of the
red bag mount.
5. Chedi and clean motor safety filter. The
red bag mount will flip forward after
removing bag. This will prevent the lid from
closing until a new bag is installed.
6. Raise red bag
mount.
7. Install bag into slots
per illustrations
pushing down until the
cardboard tab locks
into position and the
holes align. Tuck the
back end of the bag
down.
8. Close and latch canister hood.
9. Plug cord into wall outlet.
A
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh*
ener, face powder, fine dust, plaster,
soot, new carpet lint, etc. can clog
the bag and cause it to burst before
it is full. Change bag more often
when vacuuming these materials.
12