Sears 274.4279839 - Manual (Page 12)

With VCR: Setting the VCR1 Channel
The VCR 1 Channel works with VCR1 on the remote. If the VCR 1 Channel
is set, pressing VCR1 selects the channel to see the VCR picture. The
VCR 1 Channel setting depends on which diagram you have used from the
Connection Guide. If you want to turn this feature off, set the VCR 1
Channel to Disable. Refer to the chart below for your setting.
Using Your TV and Remote
1. Select the Setup Menu 13
Controls Alarm Adjust SetuD
Autooroaram
1 Label 13 clear 1
Channel Mernory; 13 Stored
Cable/Air; Cable
VCR 1 Channel; 03
A. Press TV to set the remote to
control the TV.
B. Press MENU to select the Setup
menu. This menu is white.
2. Highlight VCRl Channel 13
Controls Alarm Adjust Setup
; Autoprogram
Label 13 clear
Channel Memory: 13 Stored
1 Cable/Air: Cable
____J
VCR 1 Channel: 03
A. Press CHANNEL down to
highlight the VCR 1 Channel.
B. Press + to highlight the channel.
3. Enter channel number
4. Press DONE to save the
setting
13
Controls Alarm Adjust Setup
Autoprogram
Label 13 clear
Channel Memory: 13 Stored
1 Cabie/Air: Cable
VCR 1 Channel; 00
A. Enter channel 00, 03, or 04.
Choose your setting from the
chart below. Press + if you want
to turn this feature off (Disable).
B. Press DONE to save the setting.
Diagram used from the
Connection Guide:
Set VCRl Channel to:
IB, 1C, 2B, 2C, 3B, 3C, 4C, 5C 00
4B, 5B 3 or 4 (same as 3/4 switch)