Winco W10PTOS/A - Manual (Page 6)

6 3225-00 60706-241
ELECTRICAL CONNECTIONS
CAUTION:
Only qualified electricians should install electrical wiring.
Wiring must conform to all applicable national, state, and lo-
cal codes. (Reference: National Fire Protection Association
Manual No. 70, National Electrical Code.)
DANGER: PERSONAL INJURY
IF THE GENERATOR IS TO BE USED AS A STANDBY
POWER SOURCE, A MANUAL TRANSFER SWITCH MUST
BE INSTALLED TO SEPARATE THE GENERATOR AND THE
COMMERCIAL POWER LINES. THE SWITCH MUST ISOLATE
THE GENERATOR FROM THE COMMERCIAL POWER LINES
AND THE LOAD WHEN THE GENERATOR IS ON STANDBY,
AND MUST ISOLATE THE COMMERCIAL POWER LINES
FROM THE LOAD AND THE GENERATOR WHEN THE GEN-
ERATOR IS SUPPLYING POWER. SEE FIGURE 6
Page 4 60706-180 0310-00
ELECTRICAL CONNECTIONS
CAUTION:
Only qualified electricians should install electrical wiring.
Wiring must conform to all applicable national, state, and
local codes. (Reference: National Fire Protection Associa-
tion Manual No. 70, National Electrical Code.)
DANGER: P ERSONAL INJURY
IF THE GENERATOR IS TO BE USED AS A STANDBY
POWER SOURCE, A MANUAL TRANSFER SWITCH
MUST BE INSTALLED TO SEPARATE THE GENERATOR
AND THE COMMERCIAL POWER LINES. THE SWITCH
MUST ISOLATE THE GENERATOR FROM THE COM-
MERCIAL POWER LINES AND THE LOAD WHEN THE
GENERATOR IS ON STANDBY, AND MUST ISOLATE
THE COMMERCIAL POWER LINES FROM THE LOAD
AND THE GENERATOR WHEN THE GENERATOR IS
SUPPLYING POWER. SEE FIGURE 6
Figure
FIGURE 6