Winco DSE2548 - Manual (Page 5)

DSE2548 relay output expansion module
057-083 Issue 1 DSE2548 LED expansion operator manual 5
3 SPECIFICATIONS
3.1 PART NUMBERING
2548 - 001 - 00
At the time of this document production, there are no variants of this product and there have been no
revisions of the module hardware.
3.2 POWER SUPPLY
Minimum supply voltage
8V continuous, 4V for up to 5 minutes.
Cranking dropouts Able to survive 0V for 50mS providing the supply was at least 10V before
the dropout and recovers to 5 volts afterwards.
Maximum supply voltage 35V continuous (protection to 60V)
Maximum operating
current 112mA at 12V, 53mA at 24V
Conditions: All LED’s lit and sounder active.
Maximum standby current 74mA at 12V, 35mA at 24V
Conditions:All LED’s off and sounder inactive.
3.3 TERMINAL SPECIFICATION
Connection type Screw terminal, rising clamp, no internal spring
Min cable size 0.5mm² (AWG 20)
Max cable size 2.5mm² (AWG 14)
Recommended cable
size
Refer to table below
Product type
DSE 2548
relay
expansion
module 2548
Variant
Standard
product
00
Hardware revision
Revision 1 001