Winco DSE2548 - Manual (Page 10)

DSE2548 relay output expansion module
10 057-084 Issue 1 DSE2548 LED expansion operator manual
5.4 ID SWITCH
The rotary ID switch is used to select the ‘Identification’ of the 2548 expansion module as the host
controller is capable of giving instructions to a number of 2548 expansion modules at the same time
(consult relevant modules instructions for further details on number of supported expansion units).
The switch (located at the rear of the module) should be operated using a small screwdriver and set to
match the required ID.
NOTE : The ID MUST be a unique number, different from the ID of any other 2548 module
connected to the host controller.
If two or more 2548 controllers are required to ‘mimic’ each other then they should be
configured with different IDs, and both configured the same in the host controller.
NOTE : The selection of the ID of other types of expansion modules WILL NOT interfere/clash
with the ID of the 2548. For instance if the 2548 is set to ID4, it is acceptable to have a different
type of expansion module (for instance 2130) set to ID4 also.