beautypg.com

Vogelzang VG650ELG (new as of 2013) User Manual

Page 17

background image

VGZ-025 | 20120424.1

VG650ELG MOUNTAINEER™ |

Page 17

SERVICE HINTS continued

WIRING DIAGRAM - VG650ELG MOUNTAINEER STOVE

3. Remove glass from door frame.
4. If glass is broken, carefully remove and discard

each broken piece to avoid cuts. Discard win-

dow gasket. Replace window and gasket with

original factory replacement parts.

5. Replace new gasket starting at the bottom of

glass working along edges, being sure to center

gasket channel on glass.

6. Trim to length and butt ends together.
7. Perform replacement procedure in reverse order

after replacing glass and gasket.

8. When replacing glass into door, be sure not to

overtighten screws and clips.

DOOR GASKET REPLACEMENT

CAUTION: DO NOT OPERATE A STOVE THAT
IS MISSING DOOR GASKET MATERIAL. OVER
FIRING AND UNSAFE OPERATING CONDI-
TIONS MAY RESULT.

After extensive use, the gasket material which

provides glass and door seal may lose it’s resiliency

and will need to be replaced. Inspect glass and door
gaskets periodically to ensure proper seal; if gas-
kets become frayed or worn, replace immediately.

Procedure:

1. Ensure appliance is not in operation and is

thoroughly cooled.

2. Remove old door gasket and clean channel.
3. Using an approved, high temperature gasket

cement, apply a thin coat in bottom of channel.

4. Starting at hinge side of door, work gasket into

channel around door unit, end butt and trim to

length.

5. Close door and allow three to four hours for

cement to set before firing appliance.

BLOWER MAINTENANCE

The optional blower is maintenance free other than

cleaning. Lightly vacuum motor and air inlet

to keep free of dust and dirt.

NOTICE: ANY REPLACE-
MENT WIRING MUST HAVE
E Q U I VA L E N T I N S U L A -
TION AND TEMPERATURE

RATING (105°C).

NOTICE: DO NOT ALLOW
POWER CORD TO TOUCH
H OT S U R FAC E S . K E E P
POWER CORD AT LEAST
v--

PIPE SURFACES.

CAUTION: MOVING PARTS CAN CAUSE
INJURY. DO NOT OPERATE WITH COVER

REMOVED.

DANGER: SHOCK HAZARD. DISCONNECT
POWER SOURCE BEFORE INSTALLATION
AND WHENEVER SERVICING BLOWER

ASSEMBLY.

Vogelzang