Vizualogic RoadTrip Elite 8 - Manual (Page 18)

Center Armrest Monitor
17
Ins tallation and Conn ections
CAUTION:
The back seat passenger must tie
the safety belt before operating
the unit.
LIMITATION
The width between the front seats must be greater
than the width of the monitor.
8” LCD Monitor
22cm
● The chink between the front seat and center
console box must be greater than the thickness of
the bracket arms (At least 1.5cm).
● Both sides of the brackets should not go beyond
the case edge of center console box and too near
to driver
● When you install the bracket, please make sure
the height of the left & right bracket should be the
same, and vertical with the transverse axle.
● To ensure the top cover of the console box can be
operated, the transverse axle must be higher than
the top cover of console box 3~5cm distance..
●
→
1.5cm
22cm
If the shape of console box is similar to Figure A,
please let the bracket and top cover of console box as
90 degrees, and start to install.
OBLIQUE INSTALLATION:
If the shape of console box is similar to Figure B,
please let the bracket and incline of console box keep
parallel, and start to install.
● Before installation, please ensure the monitor will not
touch the car mats when it’s folded.
VERTICAL INSTALLATION:
3~5cm
1cm
Figure A
90
1cm
Figure B
Parallel
INCORRECT
CORRECT
INCORRECT
CORRECT
Please according to the shape of the
console box and monitor folding position
to decide the bracket installation angle and
position.
When the monitor is folded, it should be
parallel to the front of console box, and
keep distance more than 1cm.(Figure B)
CAUTION: