Vizualogic RoadTrip Elite 9 - Manual (Page 21)

Ins tallation and Conn ections
Installation Setp
1 Remove the headrest
Remove the headrest from the seat. (Figure 1)
Headrest
Headrest
stanchion
Buckle
(Figure 1)
Be sure to remove the electric sensor before
removeing the electric headrest.
CAUTION
3 Install the slide block linkage
The headrest stanchion through the slide block
linkage. (Figure 3)
Headrest stanchion
Slide block linkage
(Figure 3-1)
4
Fixed the slide block linkage
After adjusting and confirming the slide block
linkage location, please use the Allen Key to tighten
the screws. (Figure 4)
Konb
Allen key
(Figure 4)
How to adjust the length of the slide block
linkage.
Please re-assemble the slide block linkage
again after you make sure the length of the
linkage you want, and fixed by glue the joints
with strong adhesive. (Figure 3-1)
CAUTION
(Figure 3)
20
Glue
2 Measure the diameter of headrest stanchion
If the diameter of headrest stanchion is less than
16.5mm, please choose the more suitable
stanchion washer ( 10mm, 12mm or 14mm)
into the hole of the slide block linkage. (Figure 2)
Stanchion washer
( 10mm, 12mm or
14mm)
(Figure 2)
Slide block linkage
16.5mm