Vizualogic RoadTrip Elite 9 - Manual (Page 14)

MMD Set up
DVD Setup Operation
The following steps 1 to 2 are common to each of
the DVD settings described here. Refer to each
section for details.
1.
Press and hold SETUP on the remote control.
The setup menu appears on the monitor.
2.
Press or to select desired setting item
(General Setup Page / Audio Setup / Preference Page /
Password Setup Page), then press .
Further items will be displayed.
GENERAL SETUP PAGE
TV DISPLAY / ANGLE MARK / OSD LANG /
CAPTIONS / SCREEN SAVER / LAST MEMORY
AUDIO PAGE
DOLBY DIGITAL SETUP / EQUALIZER /
3D PROCESSING
PRFERENCE PAGE
TV TYPE / PBC / AUDIO / SUBTITLE / DISC MENU /
PARENTAL / DEFAULT
PASSWORD SETUP PAGE
PASSWORD
EXIT SETUP PAGE
3.
Press or to change the setting of further
items, then press ENTER.
4.
Press and hold ENTER. The settings are stored and
the setup mode is deactivated.
5.
Press SETUP or “EXIT SETUP” to return to normal
display.
‧When settings are changed, old settings are
overwritten. Make a note of current settings before
making changes. If the vehicle’s battery is
disconnected, the settings will be cleared and will
return to Factory settings.
General Setup Page
TV display, Angle mark, OSD language, Screen saver
and Last memory are adjustable.
1.
Press SETUP button on the remote control. The
setup menu appears on the monitor.
2.
Press or to select General Setup Page.
3.
Press or to select TV DISPLAY / ANGLE MARK
OSD LANG / SCREEN SAVER / LAST MEMORY,
then press ENTER to confirm a selection.
‧ Normal / PS (Pan-Scan)
Select this when connected to a conventional 4:3
size monitor. The picture will fill the entire TV
screen. Due to the mismatch in aspect ratio, parts
of the movie at the extreme left and right sides
will not be visible when playing a 16:9 size
movie.
‧ Normal / LB (Letter Box)
Select this when connected to a conventional 4:3
size (normal TV aspect ratio) monitor. There
may be black bands visible at the top and bottom
of the screen when playing a 16:9 size movie.
‧ Wide (16:9)
Select this when connected to a wide screen TV.
This is selected upon shipment from the factory.
Setting TV Display
‧For some discs, the picture may not be set to the
selected screen size.
4.
Press or to select desired screen type.
(default: Normal/PS)
5.
Press ENTER to save adjustment.
- - General Setup Page - -
TV Display
Angle Mark
OSD Lang
Captions
Screen Saver
Last Memory Normal / PS
Normal / LB
Wide
Set TV Display Mode
Wide
On
ENG
Off
On
On
13