beautypg.com

Viconics VRP5000 (Classic ZigBee) Installation Manual User Manual

Page 5

background image

0028-0265-04

5

www.viconics.com / [email protected]

Repeater Status LED

¾

Be sure all controllers and repeaters connected to a VWG and JACE are using the same PAN ID and Channel as

the JACE wireless communication card.

Repeater Wireless Adapter LED Status Indicators
1 x 200ms short blink

Power on

2 x 200ms short blinks

Power on and adapter communicating with repeater base

3 x 200ms short blinks

Power on, adapter communicating with repeater base and there is connectivity to wire-

less network

4 x 200ms short blinks

Power on, adapter communicating with repeater base, connectivity to wireless network

and VWG / JACE is communicating with wireless repeater

4 x 200ms short blinks and 1 x 1500ms long blink

Power on, adapter communicating with repeater base, connectivity to wireless network

and VWG is communicating with wireless repeater.

System Troubleshooting Recommendations

1.

If a repeater is not detected by the VWG and JACE, verify that the LED is blinking at least 4 times. If it is only blinking twice, ensure

that the PAN and Channel of the controller is the same as the VWG and JACE it must communicate with.

2.

When commissioning a network, it is recommended to use channels 15, 25 or 26. Alternate these channels between floors.

3.

If a particular repeater or controller refuses to join the network and cannot be seen by the VWG and JACE. Please move closer to the

VWG and JACE until it has joined the network and it is added to the database. It can then be re-located to its original position.

Terminal Block

Two wires power the repeater. No other wiring is required. Simply connect 24 Vac to the terminal block as shown below.