Viconics VST5000 (Classic ZigBee) User Guide - Manual (Page 11)

11 VST5000W5000W Wireless Survey Tools User Guide
new network. I.E. this is ONLY applicable during the initial
network start-up.
1. First power up the orange devices / nodes /
controllers in sequence as showed and wait until
they are joined to the network or matched to
their offline created counterparts ( see the device
management section in this manual on how to
create offline devices / nodes / controllers & match
them to discovered devices ).
2. All the remaining yellow devices / nodes / controllers
can now all be powered up to also join the network.
3. This start-up sequencing allows for ALL devices to be
discovered without creating orphan nodes (fig. 16).
Jace
Coordinator
Proposed
location
Power
#1
Power
#2 Power
#3
Power
#4
Power
#5
Power
#6
t
t
t
t
t t
t
t
t
t
t
t
t
t
t
t
t
t
t t
t
t
t t
t
t t
t
t t
t
t
t
t
t
t t
Fig. 16
Points to Remember:
• Always write your transmission results on a plan
when possible.
• Use REP5000W repeaters if remote devices are too
far to bridge or the signal is too weak.
• You can move the coordinator (VWG or Jace-Driver)
to a new location if it helps create better clusters of
controllers.
• You “should” always plan for a floor by floor
horizontal architecture vs. a vertical one.
• Additional coordinator (VWG or Jace-Driver) can
be used when clusters become too far apart in an
installation.
• You can always call Viconics technical support for
recommendations if you have a floor plan layout
available for review.
Disclaimer
NO WARRANTY. Viconics, Inc. (herein after referred to
as “Viconics”) makes no warranty as to the accuracy of
or use of this technical documentation. Any use of the
technical documentation or the information contained
therein is solely at the risk of the user.
Documentation may include technical or other
inaccuracies or typographical errors. Viconics reserves
the right to make changes to this document without
prior notice, and the reader should in all cases consult
Viconics to determine whether any such changes have
been made. The information in this publication does
not represent a commitment on the part of Viconics.
Viconics shall not be liable for incidental or
consequential damages resulting from the furnishing,
performance, or use of this material.
Electronic controls are static sensitive devices.
Discharge yourself properly before manipulation and
installing the Viconics wireless gateway.
Viconics Inc. may not be held liable for continued
reliable or robust operation of any and all wireless
based devices. Although Viconics has taken many
precautions in assuring the robustness of the VT7000
series wireless controller product line and associated
network access point. Please note; future application
of additional wireless devices utilizing the same or
similar channels and / or frequencies may degrade
performance of overall system and / or reliability.
Non-approved modifications or changes made to
the Wireless Communication Card VWG or wireless
controllers may void the FCC compliance of the
VWG and wireless controllers.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE
FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.